Cisco Aironet Wave 2 - debug dot11 sensor

debug dot11 sensor
To enable debugging of 802.11 sensors, use the debug dot11 sensor command.
debug dot11 sensor {dns | file-transfer | mail-server | ping | radius | ssh | telnet |
web-server}
Syntax Description
Enables debugging of 802.11 sensor DNSdns
Enables debugging of 802.11 sensor file transferfile-transfer
Enables debugging of 802.11 sensor mail servermail-server
Enables debugging of 802.11 sensor pingping
Enables debugging of 802.11 sensor radiusradius
Enables debugging of 802.11 sensor SSHssh
Enables debugging of 802.11 sensor Telnet.telnet
Enables debugging of 802.11 sensor web serverweb-server
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of 802.11 sensor file transfer:
cisco-wave2-ap# debug dot11 sensor file-transfer
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
56
debug Commands
debug dot11 sensor