Cisco Aironet Wave 2 - debug process memory

debug process memory
To process memory debugging, use the debug process memory command.
debug process memory {diff |realtime [interval interval-in-seconds ] |start}
Syntax Description
Process memory debug show diffdiff
Process memory real time debugrealtime
Update interval; valid range 1 to 1000000 seconds
interval
Process memory debug startstart
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable the start of debugging of process memory:
cisco-wave2-ap# debug process memory start
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
73
debug Commands
debug process memory