show spectrum
To view the show commands of the spectrum firmware, use the show spectrum command.
show spectrum {list |recover |status }
Syntax Description
Lists the spectrum FW data fileslist
Displays the spectrum FW recover countrecover
Displays the spectrum FW statusstatus
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view the spectrum firmware status:
cisco-wave2-ap# show spectrum status
Spectrum FW status slot 0:
version: 1.15.4
status: up, crashes 0, resets 0, radio reloads 0
load: 37.00 34.75 33.50 33.25
NSI Key: 26c1bd25893a4b6dd3a00fe71735d067
NSI: not configured
reg_wdog: 255 26309 0
dfs_wdog: 0
dfs_freq: 0
Spectrum FW status slot 1:
version: 1.15.4
status: up, crashes 0, resets 0, radio reloads 0
load: 37.25 38.00 38.75 39.00
NSI Key: 26c1bd25893a4b6dd3a00fe71735d067
NSI: not configured
reg_wdog: 255 26309 0
dfs_wdog: 0
dfs_freq: 0
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
134
show Commands
show spectrum
To Next Page
Loading...
