show controllers wired
To view the wired interface, use the show controllers wired command.
show controllers wired wired-interface-number
Syntax Description
Wired interface number from 0 to
3
wired-interface-number
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view information about the controllers' wired interface whose
ID is 1:
cisco-wave2-ap# show controllers wired 1
wired1 Link encap:Ethernet HWaddr C8:8B:6A:33:59 eMac Status: DOWN
inet addr:9.11.8.104 Bcast:9.255.255.255 Mask:255.255.255.255
DOWN BROADCAST RUNNING PROMISC MULTICAST MTU:2400 Metric:1
RX packets:38600 errors:0 dropped:1 overruns:0 frame:0
TX packets:179018 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:80
RX bytes:3812643 (3.6 MiB) TX bytes:54721869 (52.1 MiB)
Gig Emac1 Counters
---------------------
0 Good octets rx, 0 Bad octets rx, 0 Unicast frames rx,
0 Broadcast frames rx, 0 Multicast frames rx, 0 64 byte frames rx,
0 65_TO_127 byte frames, 0 128_TO_255 byte frames, 0 256_TO_511 byte frames,
0 512_TO_1023 byte frames, 0 1024_TO_MAX byte frames, 0 Good octets tx,
0 Unicast frames tx, 0 Multicast frames tx, 0 Broadcast frames tx,
0 Crc errors sent, 0 Flow control rx, 0 Flow control tx,
0 Rx fifo overrun, 0 Undersized rx, 0 Fragments rx,
0 Oversize rx, 0 Jabber rx, 0 Mac rx error,
0 Bad crc event, 0 Collision, 0 Late collision,
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
103
show Commands
show controllers wired
To Next Page
Loading...
