Cisco Aironet Wave 2 - capwap ap mode

capwap ap mode
To configure AP mode, use the capwap ap mode command.
capwap ap mode {bridge | local}
Syntax Description
Enables bridge
mode
bridge
Enables local modelocal
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to configure the AP to operate in local mode:
cisco-wave2-ap# capwap ap mode local
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
17
capwap Commands
capwap ap mode