Cisco Aironet Wave 2 - capwap ap

capwap ap
To configure the primary, secondary and tertiary controllers for the AP, use the capwap ap command.
capwap ap {primary-base | secondary-base | tertiary-base}
controller-name controller-ip-address
Syntax Description
Configure AP's primary controllerprimary-base
Configure AP's secondary controllersecondary-base
Configure AP's tertiary controllertertiary-base
Name of the controller
controller-name
IP address of the controller.
controller-ip-address
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to configure the primary controller for the AP:
cisco-wave2-ap# capwap ap primary-base wlc-5520 209.165.200.224
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
10
capwap Commands
capwap ap