Cisco ASA 5506W-X

wLAN
Not in use on the ASA
5506-X or the ASA
5506-H.
Association status of the
wireless connection on
the ASA 5506W-X:
• Chirping green –
Normal operating
condition, but no
wireless client is
present.
• Green – Normal
operating condition,
at least one wireless
client is associated.
• Blinking amber –
Software upgrade in
progress.
•
Green, red, amber
sequence –
Discovery/join
process in progress.
• Blinking red –
Ethernet link not
operational.
• Unlit – Wireless is
not operational.
4Active
Status of the failover pair:
• Solid green –
Failover pair
operating normally.
The LED is green
always unless the
ASA in an HA pair.
• Amber – When the
ASA is in an HA
pair, the LED is
amber for the
Standby unit.
• Unlit – Failover is
not operational.
3
Network Port Status
On the rear panel of the ASA 5506-X and ASA 5506W-X, a pair of LEDs (link status and connection status)
for each of the eight Gigabit Ethernet network ports, and the Gigabit Ethernet management port.
On the rear panel of the ASA 5506H-X, a pair of LEDs (link status and connection status) for each of the four
Gigabit Ethernet network ports, and the Gigabit Ethernet Management port.
Link status (L):
• Unlit – No link, or port is not in use.
• Solid green – Link established.
• Flashing green – Link activity.
Connection-speed status (S):
• One blink every three seconds – 10 Mbps.
Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide
10 Online Only
Overview
LEDs