1-4
Cisco ASA Series CLI Configuration Guide
Chapter 1 Managing Software and Configurations
Command Purpose
Step 1
more system:running-config
Example:
active# more system:running-config
(If there is a configuration migration) The output shows the
configuration on the terminal so that you can back up your
configuration. Copy the output from this command, then paste the
configuration in to a text file.
Note If you are upgrading from a pre-8.3 version, then the
running configuration is backed up automatically.
For other methods of backing up, see the configuration guide.
Step 2
copy tftp://server[/path]/asa_image_name
{disk0:/ | disk1:/}[path/]asa_image_name
Example:
active# copy
tftp://10.1.1.1/asa901-smp-k9.bin
disk0:/asa901-smp-k9.bin
Copies the ASA software to the active unit flash memory. For
other methods than TFTP, see the copy command.
Step 3
failover exec mate copy /noconfirm
tftp://server[/path]/filename {disk0:/ |
disk1:/}[path/]filename
Example:
active# failover exec mate copy /noconfirm
tftp://10.1.1.1/asa901-smp-k9.bin
disk0:/asa901-smp-k9.bin
Copies the software to the standby unit; be sure to specify the
same path as for the active unit.
Step 4
copy tftp://server[/path]/asdm_image_name
{disk0:/ | disk1:/}[path/]asdm_image_name
Example:
active# copy tftp://10.1.1.1/asdm-701.bin
disk0:/asdm-701.bin
Copies the ASDM image to the active unit flash memory.
Step 5
failover exec mate copy /noconfirm
tftp://server[/path]/asdm_image_name
{disk0:/ | disk1:/}[path/]asdm_image_name
Example:
active# failover exec mate copy /noconfirm
tftp://10.1.1.1/asdm-701.bin
disk0:/asdm-701.bin
Copies the ASDM image to the standby unit; be sure to specify the
same path as for the active unit.
Step 6
configure terminal
Example:
active(config)# configure terminal
If you are not already in global configuration mode, accesses
global configuration mode.
Step 7
show running-config boot system
Example:
hostname(config)# show running-config boot
system
boot system disk0:/cdisk.bin
boot system disk0:/asa841-smp-k9.bin
Shows the current boot images configured (up to 4). The ASA
uses the images in the order listed; if the first image is
unavailable, the next image is used, and so on. You cannot insert
a new image URL at the top of the list; to specify the new image
to be first, you must remove any existing entries, and enter the
image URLs in the order desired, according to the following steps.
To Next Page
Loading...
