Cisco ASA 5525-X Cli Configuration Guide

1-13
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the Identity Firewall
Task Flow for Configuring the Identity Firewall
What to Do Next
Configure access rules for the Identity Firewall. See Configuring Identity-Based Security Policy,
page 1-18.
Configuring Identity Options
Perform this procedure to add or edit the Identity Firewall feature; select the Enable check box to enable
the feature. By default, the Identity Firewall feature is disabled.
Prerequisites
Before configuring the identify options for the Identity Firewall, you must you must meet the
prerequisites for the AD Agent and Microsoft Active Directory. See Prerequisites, page 1-8 the
requirements for the AD Agent and Microsoft Active Directory installation.
To configure the Identity Options for the Identity Firewall, perform the following steps:

Cisco ASA 5525-X Specifications

General

Maximum Concurrent Sessions	500, 000
Maximum VPN Peers	750
Memory	8 GB
Flash Memory	8 GB
Power Supply	AC
Rack Units	1U
Interfaces	8 x 1Gbps (RJ-45/SFP)