Cisco ASA 5525-X - Monitoring Interfaces; Configuration Examples for ASA 5510 and Higher Interfaces; Physical Interface Parameters Example

1-34
Cisco ASA Series CLI Configuration Guide
Chapter 1 Starting Interface Configuration (ASA 5510 and Higher)
Monitoring Interfaces
Cryptochecksum: 718e3706 4edb11ea 69af58d0 0a6b7cb5
70291 bytes copied in 3.710 secs (23430 bytes/sec)
[OK]
hostname(config)# reload
Proceed with reload? [confirm] Y
Monitoring Interfaces
To monitor interfaces, enter one of the following commands:
Configuration Examples for ASA 5510 and Higher
Interfaces
This section includes the following topics:
• Physical Interface Parameters Example, page 1-34
• Subinterface Parameters Example, page 1-35
• Multiple Context Mode Example, page 1-35
• EtherChannel Example, page 1-35
Physical Interface Parameters Example
The following example configures parameters for the physical interface in single mode:
interface gigabitethernet 0/1
speed 1000
duplex full
no shutdown
Command Purpose
show interface
Displays interface statistics.
show interface ip brief
Displays interface IP addresses and status.
show lacp {[channel_group_number] {counters
| internal | neighbor} | sys-id}
For EtherChannel, displays LACP information such as traffic statistics,
system identifier and neighbor details.
show port-channel [channel_group_number]
[brief | detail | port | protocol |
summary]
For EtherChannel, displays EtherChannel information in a detailed and
one-line summary form. This command also displays the port and
port-channel information.
show port-channel channel_group_number
load-balance [hash-result {ip | ipv6 |
l4port | mac | mixed | vlan-only}
parameters]
For EtherChannel, displays port-channel load-balance information along
with the hash result and member interface selected for a given set of
parameters.