1-13
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring EIGRP
Customizing EIGRP
Detailed Steps
Command Purpose
Step 1
router eigrp as-num
Example:
hostname(config)# router eigrp 2
Creates an EIGRP routing process and enters router configuration
mode for this EIGRP process.
The as-num argument is the autonomous system number of the
EIGRP routing process.
Step 2
default-metric bandwidth delay reliability
loading mtu
Example:
hostname(config)# router eigrp 2
hostname(config-router)# default-metric
bandwidth delay reliability loading mtu
(Optional) Specifies the default metrics that should be applied to
routes redistributed into the EIGRP routing process.
If you do not specify a default metric in the EIGRP router
configuration, you must specify the metric values in each
redistribute command. If you specify the EIGRP metrics in the
redistribute command and have the default-metric command in
the EIGRP router configuration, the metrics in the redistribute
command are used.
Step 3
Do one of the following to redistribute the selected route type into the EIGRP routing process:
redistribute connected [metric bandwidth
delay reliability loading mtu] [route-map
map_name]
Example:
hostname(config-router): redistribute
connected [metric bandwidth delay
reliability loading mtu] [route-map
map_name]
Redistributes connected routes into the EIGRP routing process.
You must specify the EIGRP metric values in the redistribute
command if you do not have a default-metric command in the
EIGRP router configuration.
redistribute static [metric bandwidth
delay reliability loading mtu] [route-map
map_name]
Example:
hostname(config-router): redistribute
static [metric bandwidth delay reliability
loading mtu] [route-map map_name]
Redistributes static routes into the EIGRP routing process.
To Next Page
Loading...
