Cisco ASA 5555-X Configuration Guide

3-20
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 3 Access Control Lists
Monitoring ACLs
same changes again if you would like to). If you save the revert or configuration session, the changes
are committed, but the session remains active. You can open the session and revert or recommit the
changes. You can avoid the prompt by including the noconfirm option and optionally, the desired
save option.
• abort—(Uncommitted sessions only.) To abandon your changes and delete the session. If you want
to keep the session, exit the session and use the clear session session_name configuration
command, which empties the session without deleting it.
• revert—(Committed sessions only.) To undo your changes, returning the configuration back to what
it was before you committed the session, and delete the session.
• show configuration session [session_name]—To show the changes made in the session.
Monitoring ACLs
To monitor ACLs, enter one of the following commands:
Command Purpose
show access-list [name]
Displays the access lists, including the line
number for each ACE and hit counts. Include an
ACL name or you will see all access lists.
show running-config access-list [name]
Displays the current running access-list
configuration. Include an ACL name or you will
see all access lists.

Cisco ASA 5555-X Specifications

General

Firewall Throughput	4 Gbps
Maximum Concurrent Sessions	1, 000, 000
Security Contexts	50
VPN Throughput	1.2 Gbps
RAM	8 GB
Storage	120 GB SSD
Power Supply	Dual, Hot-swappable
Form Factor	1RU
Interfaces	8 x 1 Gigabit Ethernet