27-9
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 27 Configuring Network Object NAT
Configuring Network Object NAT
Figure 27-11 Configuring Dynamic PAT
Step 6
In the Translated Addr field, specify the mapped IP address.
Note You can share this mapped IP address across different dynamic PAT rules, if desired.
Do one of the following:
• Type a host IP address.
• Type an interface name or click the browse button , and choose an interface from the Browse
Translated Addr dialog box.
Figure 27-12 Browse Dialog Box
If you specify an interface name, then you enable interface PAT, where the specified interface IP
address is used as the mapped address. With interface PAT, the NAT rule only applies to the specified
mapped interface. (If you do not use interface PAT, then the rule applies to all interfaces by default.)
See Step 8 to optionally also configure the real interface to be a specific interface instead of --Any--.
Note You cannot specify an interface in transparent mode.
• Click the browse button , and choose an existing host address from the Browse Translated Addr
dialog box. You can also create a new named object from the Browse Translated Addr dialog box
and use this object as the mapped address.
To Next Page
Loading...
