27-10
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 27 Configuring Network Object NAT
Configuring Network Object NAT
Figure 27-13 Browse Dialog Box
See the “Guidelines and Limitations” section on page 27-2 for information about disallowed mapped IP
addresses.
Step 7 (Optional) Click Advanced, and configure the following options in the Advanced NAT Settings dialog
box. When you are finished, click OK.
Figure 27-14 Configuring Advanced NAT Settings
• To translate the IP address in DNS replies, check the Translate DNS replies for rule check box.
Be sure DNS inspection is enabled (it is enabled by default). See the “DNS and NAT” section on
page 26-21 for more information.
• To specify the real and/or mapped interfaces where this NAT rule should apply, under Interface,
choose the source and destination interfaces.
By default, the rule applies to all interfaces.
You return to the Add/Edit Network Object dialog box.
Step 8 Click OK, and then Apply.
To Next Page
Loading...
