Cisco ASR-920-24SZ-IM User Manual

SUMMARY STEPS
1.
Attach the AC power retainer cord as shown in the figure below.
2.
Lift the power retainer and plug in the AC power supply.
3.
Push the retainer cord towards the power supply cord to lock it in place as shown in the figure below.
4.
Connect the other end of the power cord to an AC-input power source.
5.
Verify power supply operation by checking that the power supply LED is green.
6.
If the LEDs indicate a power problem, see LED Indicators section for troubleshooting information.
7.
If you are installing a redundant power supply, repeat these steps for the second power source.
DETAILED STEPS
Step 1
Attach the AC power retainer cord as shown in the figure below.
Figure 38: Attaching the AC Power Retainer Cord
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
87
Installing the Router
Installing an AC power Supply

Cisco ASR-920-24SZ-IM Specifications

General

Brand	Cisco
Model	ASR-920-24SZ-IM
Category	Network Router
Language	English