Display Contents/LED Status and MeaningType of IndicatorComponent
INIT—Card is inserted and microcontroller is initialized
BOOT—Board is powered on and CPU is booting
IMEM—Start initializing memory
IGEN—Start initializing the board
ICBC—Start initializing communication with the microcontroller
SCPI—Board is not plugged in properly
RSP-440/RSP 440-Lite:
• STID—CBC was unable to read slot ID pins correctly
• PSEQ—CBC detected power sequencer failure
• DBPO—CBC detected an issue during board power up
• KPWR—CBC detected an issue during board power up
• LGNP—CBC detected an issue during board power up
• LGNI—CBC detected an issue during board power up
RMN—All tests are finished and ROMMON is ready for commands
LOAD—Downloading MBI image to CPU
RRST—ROMMON is performing a soft reset after 5 consecutive MBI
validation requests timed out
MVB—ROMMON trying MBI validation boot
MBI—Starting execution of MBI
IOXR—Cisco IOS XR software is starting execution
LDG—The RSP is loading (MBI started and card preparing for activity)
INCP—The software or configuration is incompatible with the RSP
OOSM—The RSP is in Out of Service, Maintenance mode
ACTV—RSP role is determined to be active RSP
STBY—RSP role is determined to be standby RSP
PREP—Preparing disk boot
Alphanumeric displayRSP-440
RSP-440 Lite
RSP-880
RSP880-LT
RSP4-S
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
201
Troubleshooting the Installation
Identifying Startup Issues
To Next Page
Loading...
Need help?
General
