Cisco ATA 186 Datasheet

© 2006 Cisco Systems, Inc. All rights reserved.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Page 3 of 7
SYSTEM REQUIREMENTS
A
Regular analog telephones
B
10BaseT category-5 cable to access IP network
C
Power for AC/DC power adaptor
SOFTWARE SPECIFICATIONS
Voice-over-IP (VoIP) Protocols
• SIP (RFC 2543)
• SCCP
Voice Codecs*
• G.729, G.729A, G.729AB2
• G.723.1
• G.711a-law
• G.711µ-law
* In simultaneous dual-port operation, the second port is limited to G.711 when using G.729.
Provisioning and Configuration
• DHCP (RFC 2131)
• Web configuration via built-in Web server
• Touch-tone telephone keypad configuration with voice prompt
• Basic boot provisioning (RFC 1350 TFTP Profiling)
• Dial plan provisioning
• Cisco Discovery Protocol for SCCP
Security
• RC4 encryption for TFTP configuration profiles
Dual-Tone Multi-Frequency (DTMF)
• DTMF tone detection and generation
Out-of-Band DTMF
• RFC 2833 AVT tones for SIP, MGCP, SCCP
Call Progress Tones
• Configurable for two sets of frequencies and single set of on/off cadence

Cisco ATA 186 Specifications

General

Operating Temperature	32°F to 104°F (0°C to 40°C)
Protocol	SIP, H.323
Network Interface	10/100BASE-T Ethernet
Audio Codec Support	G.729a, G.723.1
Power Supply	5V DC
Weight	0.23 kg (0.5 lb)
Relative Humidity	10 to 90% noncondensing
Ports	2 RJ-11 FXS ports