1-8
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Chapter 1 Cisco Analog Telephone Adaptor Overview
Software Features
Mid-call Services
The method of initiating and using mid-call services for the SCCP protocol differs according to mode.
The following three modes are available for invoking mid-call services:
• Bellcore Style (default)
• Cisco VG248 Style
• Cisco ATA Style
The mode can be configured using bits 28 and 29 of the ConnectMode parameter (see the
“ConnectMode” section on page 5-21).
Table 1-2 lists the mid-call services that the Cisco ATA supports for each of the three modes. Table 1-2
also includes references to where the end-user procedure is described for each service.
Table 1-1 Pre-call Services and Where to Find End-user Procedures
Service Procedure Reference
Voice mail access Access Voicemail, page A-2
Change access code Change Your Pre-Call Service Access Code, page
A-2
Forward all calls to another number Activate Call-Forward-All, page A-2
Cancel the forwarding of all calls Cancel Call-Forward-All, page A-2
Redial the most recent number dialed Redial, page A-2
Use speed dial Speed Dial, page A-3
Answer a call in your call-pickup group Call Pickup, page A-3
Answer a call outside of your call-pickup group Group Call Pickup, page A-3
Set up a conference MeetMe Conference, page A-4
Table 1-2 Mid-call Services and Where to Find End-user Procedures
Style and Related Services Procedure Reference
Bellcore style (default) services:
• Call transfer
• Conference call
Bellcore Style, page A-4
Cisco VG248 style services:
• Three-way call
• Call transfer
• Conference call
Cisco VG248 Style, page A-5
Cisco ATA style services:
• Call hold/resume
• Call transfer
• Conference call
Cisco ATA Style, page A-6
To Next Page
Loading...
Need help?
General
