Name: Cisco C390
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

You can log in to the Cisco C390 appliance using one of two interfaces: the

web-based interface or the command-line interface.

Web-Based Interface

Step 1 For web browser access via the Ethernet port (see the “Connect to the

Appliance” section on page 7), go to the appliance’s management

interface by entering the following URL in a web browser:

http://192.168.42.42

Step 2 Log in with the following credentials:

• Username: admin

• Password: ironport

Command-Line Interface

Step 1 Access the command-line interface locally or remotely:

• To access the CLI locally, set up a terminal to connect to the serial

port using 9600 bits, 8 bits, no parity, 1 stop bit (9600, 8, N, 1) and

flow control set to Hardware. To physically connect the terminal,

see the

“Connect to the Appliance” section on page 7).

• To access the CLI remotely, initiate an SSH session to the IP address

192.168.42.42.

Step 2 Log in as admin with the password ironport.

Step 3 At the prompt, run the systemsetup command.

Questions and Answers:

Need help?

Do you have a question about the Cisco C390 and is the answer not in the manual?

Cisco C390 Specifications

General