Chapter 2 Installation
EMC Regulatory Statements
2-2
Catalyst 2900 Series XL Modules Hardware Installation Guide
78-5912-03
EMC Regulatory Statements
U.S.A.
U.S. regulatory information for this product is in the front matter of this manual.
For translated warnings, see Appendix C, “Translated Safety Warnings.”
Taiwan
Avoiding Electrostatic Discharge
Before you install the module, ground yourself by touching a piece of metal to
avoid electrostatic discharge (ESD). You should also take the following
precautions to prevent damage to the board:
• Keep the module in its antistatic shielded bag until you are ready to install it.
• Handle the modules by the edges.
• Do not touch the components, pins, leads, or solder connections.
Installing a Module
The switch expansion slots are numbered 1 (left) and 2 (right). You can install
either of the modules into either slot. Blank faceplates on the Catalyst 2924M XL
switch cover the slots, as shown in Figure 2-1
To Next Page
Loading...
