5
Warning
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.
Statement 39
Warning
If a redundant power system (RPS) is not connected to the switch, install an RPS connector cover on the back of
the switch.
Statement 265
Warning
Class 1 laser product.
Statement 1008
Warning
For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection: 10/100/1000 Ethernet.
Statement 1044
Warning
Voltages that present a shock hazard may exist on Power over Ethernet (PoE) circuits if interconnections are made
using uninsulated exposed metal contacts, conductors, or terminals. Avoid using such interconnection methods,
unless the exposed metal parts are located within a restricted access location and users and service people who
are authorized within the restricted access location are made aware of the hazard. A restricted access area can
be accessed only through the use of a special tool, lock and key or other means of security.
Statement 1072
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
To Next Page
Loading...
Need help?
General
