20
Catalyst 3750-X and 3560-X Switch Getting Started Guide
OL-19590-01
Obtaining Documentation and Submitting a Service Request
Resetting the Switch to the Default Settings
Caution Resetting the switch deletes the configuration and restarts the switch.
1. Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds.
2. Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then
the switch restarts.
The switch now behaves like an unconfigured switch. You can enter the switch IP information by using
Express Setup as described in the “Running Express Setup” section on page 3.
Accessing Help Online
First look for a solution to your problem in the troubleshooting section of the hardware installation guide
or the software configuration guide on Cisco.com. You can also access the Cisco Technical Support and
Documentation website for a list of known hardware problems and extensive troubleshooting
documentation.
Obtaining Documentation and Submitting a Service Request
For information on obtaining documentation, submitting a service request, and gathering additional
information, see the monthly What’s New in Cisco Product Documentation, which also lists all new and
revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Subscribe to the What’s New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed
and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free
service and Cisco currently supports RSS Version 2.0.
To Next Page
Loading...
Need help?
General
