Cisco Catalyst 3750G - User Manual

Getting Started
Guide
Catalyst 3750G Integrated Wireless LAN Controller Switch
Getting Started Guide
INCLUDING LICENSE AND WARRANTY
1 About this Guide
2 Taking Out What You Need
3 Running Express Setup
4 Managing the Switch
5 Preparing the Wireless LAN Controller for Operation
6 Planning Switch Stacks
7 Rack-Mounting
8 In Case of Difficulty
9 Obtaining Documentation
10 Documentation Feedback

Cisco Catalyst 3750G Specifications

General

Model	Cisco Catalyst 3750G
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
DRAM	128 MB
Flash Memory	16 MB
MAC Address Table Size	12, 000 entries
VLANs	1005
Operating Humidity	10% to 85% non-condensing
Ports	48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP Gigabit Ethernet ports
Jumbo Frames	Up to 9216 bytes
Power Supply	AC
Operating Temperature	0 to 45°C

Summary

Running Express Setup

Managing the Switch

Using the Device Manager

Preparing the Wireless LAN Controller for Operation

Using the Configuration Wizard to Configure the Controller

Steps to configure the wireless LAN controller using the initial setup wizard.

Planning Switch Stacks

Rack-Mounting

Rack-Mounting Preparations and Warnings

Rack-Mounting Procedures

Step-by-step instructions for attaching mounting brackets and securing the switch in a rack.

Connect the StackWise Cables

Connect to the Switch Ports

Install the SFP Modules and Connect to the Ports

In Case of Difficulty

Troubleshooting Express Setup

Common issues and solutions when Express Setup fails or the page does not appear.

Resetting the Switch

Procedure to reset the switch configuration and reboot it to its factory default state.

Troubleshooting the Wireless Controller

Accessing Help Online