Cisco Catalyst 9600 Series - Page 13

Figure 9: Pivoting the Ejector Levers Inward
Ejector levers1
Step 7 Install necessary transceivers, if any, into the module ports.
For installation instructions along with safety warnings for the various types of transceivers, see
https://www.cisco.com/en/US/products/hw/modules/ps5455/prod_installation_guides_list.html
Step 8 Attach the necessary network interface cables or other devices to the interface ports.
Step 9 Check the status of the line card:
a) Ensure that the status LED is green.
b) When the switch is online, enter the show module command. Verify that the system acknowledges the
new line card and that the line card status is OK.
c) If the line card is not operational, reseat it. If it is still not operational, contact your Cisco customer service
representative.
Cisco Catalyst 9600 Series Line Card Installation Note
13
Installing a Line Card