Cisco Catalyst 9600 Series Installation Note

Figure 2: 40 G/1 G Port Numbering on C9600-LC-24C
Figure 3: 100 G Port Numbering on C9600-LC-24C
By default, all the interfaces on a C9600-LC-24C are 40 G/1 G enabled. The default 40 G/1 G interfaces can
be configured to function as 100 G ports using the CLI. However, from each port group, only the odd numbered
ports can be configured with 100 G speed; the even numbered ports in a port group are disabled.
Figure 4: 40 G/1 G (Default) Configuration on C9600-LC-24C
Figure 5: 100 G Configuration on C9600-LC-24C
Cisco Catalyst 9600 Series 48-Port 25 G/10 G/1 G (C9600-LC-48YL)
The following figure shows the front view of a 48-port 25 G/10 G/1 G (C9600-LC-48YL) with the major
features identified.
Cisco Catalyst 9600 Series Line Card Installation Note
4
Cisco Catalyst 9600 Series 48-Port 25 G/10 G/1 G (C9600-LC-48YL)

Cisco Catalyst 9600 Series Specifications

General

Series	Catalyst 9600 Series
Category	Switch
Switching Capacity	Up to 25.6 Tbps
Software	Cisco IOS XE
Form Factor	Modular chassis
Purpose	Enterprise campus core and distribution
Ports	10G, 25G, 40G, 100G, 400G
Redundancy	Yes, supports redundant power supplies and fans
Stacking	Virtual Stacking supported
Security	Advanced security features including MACsec encryption
Management	Cisco DNA Center, CLI, SNMP
Uplink Ports	40G, 100G
Power Supply	Redundant, hot-swappable
Operating Temperature	0°C to 45°C (32°F to 113°F)
Port Density	Up to 384 ports
Weight	Starting at 75 lbs (34 kg)
Modular Slots	Up to 6 line card slots