Cisco Catalyst 9800-L - Connecting the Management Ethernet Port; Installing a Security Lock; Security Lock Installation

Procedure
Step 1 Insert an Ethernet RJ-45 cable into the MGMT port.
Step 2 Insert the other end of the RJ-45 cable to your management device or network.
Installing a Security Lock
The controller has a security slot on the back panel. You can install an optional customer-supplied Kensington
lock, such as the type that is used to secure a laptop computer, to secure the controller. See the "Cisco Catalyst
9800-L Wireless Controller Rear Panel" section for the location of the security lock.
Installing the Cisco Catalyst 9800-L Wireless Controller
13
Installing the Cisco Catalyst 9800-L Wireless Controller
Installing a Security Lock