DescriptionNetwork Module
This module has two 40G slots with a QSFP+ connector in each slot.
This module is supported only on C9200 Multigigabit Ethernet switches.
C9200-NM-2Q
Insert this blank module when the switch has no uplink ports to enable
sufficient airflow.
C9200-NM-BLANK
For information about installing a network module, see Installing a Network Module, on page 34.
Note
Rear Panel
The switch rear panel includes StackWise connectors, fan modules, and power supply modules.
Figure 5: Rear Panel of a C9200L Switch
Blue Beacon LED4RJ-45 console port1
MGMT (RJ-45
10/100/1000 management
port)
5Fixed fan modules on
C9200L switches
2
StackWise-80 port
connectors
6Power supply module
slots
3
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
8
Product Overview
Rear Panel
To Next Page
Loading...
