To Next PageTo Next Page
Need help?Do you have a question about the Cisco Catalyst C9500-24Y4C and is the answer not in the manual?
General| Model | C9500-24Y4C |
|---|---|
| Category | Switch |
| Product Series | Catalyst 9500 |
| Switching Capacity | 1.92 Tbps |
| Forwarding Rate | 1.44 Bpps |
| Rack Units | 1RU |
| Operating System | Cisco IOS XE |
| RAM | 16 GB |
| Flash Memory | 16 GB |
| VLANs Supported | 4096 |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Ports | 24 x 25 Gigabit Ethernet ports and 4 x 100 Gigabit Ethernet QSFP28 ports |
| Redundancy | Power supply |
| Stacking | Yes |
| Jumbo Frame Support | 9198 bytes |
| MAC Address Table Size | 128, 000 entries |
| Operating Humidity | 5% to 90% non-condensing |
| Power Supply | Dual hot-swappable power supplies |
| Weight | 16.33 lbs (7.41 kg) |
Lists different Cisco Catalyst 9500 series switch models.
Describes the components and ports on the front panel.
Explains port numbering and mapping for base models.
Explains port numbering for HPS models.
Details the types of console ports available.
Critical safety instructions and general warnings.
General requirements for the installation environment.
Procedures and importance of proper grounding.
Safety practices for electrical work.
Guidelines to prevent electrostatic discharge.
Overview of the switch installation process.
How to connect the system ground.
Step-by-step guide for grounding.
General procedure for installing the switch.
Instructions for mounting the switch in a rack.
Detailed steps for mounting in a rack.
Procedure for installing network modules.
Procedure for installing a power supply unit.
How to connect power supplies to the source.
Specific steps for AC power connection.
Specific steps for DC power connection.
Guidelines for installing fan modules.
Procedure for installing a fan module.
Procedure for installing an SSD module.
Approach to isolating issues.
Steps to resolve power supply issues.
Steps to resolve fan tray issues.
Explains port LEDs and mode selection.
Steps to configure via WebUI.
Steps to configure via CLI.
