Need help?Do you have a question about the Cisco Catalyst C9200CX-12P-2X2G and is the answer not in the manual?
General| Model | Cisco Catalyst C9200CX-12P-2X2G |
|---|---|
| Device Type | Switch |
| Manageable | Yes |
| Ports | 12 |
| PoE+ | Yes |
| Power over Ethernet (PoE) | Yes |
| PoE Budget | 240W |
| Stacking | Yes |
| Operating System | Cisco IOS XE |
| DRAM | 4 GB |
| Flash Memory | 4 GB |
| Jumbo Frames | 9216 bytes |
| Input voltage | 100 - 240 VAC |
| Power Supply | Internal |
| MAC Address Table Size | 16000 |
| Dimensions (H x W x D) | 44 x 440 x 310 mm |
Details the different Cisco Catalyst 9200CX Series switch models and their supported features.
Identifies and describes the components located on the front panel of the switch.
Explains the functionality, cable requirements, and specifications of 10/100/1000 Ethernet ports.
Describes the Power over Ethernet (PoE) and PoE+ capabilities, including supported standards and features.
Provides information on the uplink ports, including support for SFP+ and SFP modules.
Provides essential safety precautions and warnings to be observed before and during installation.
Outlines best practices and environmental considerations for installing the switch.
Specifies environmental and physical conditions required for proper switch installation and operation.
Instructions on powering on the switch and verifying its operational status after installation.
Details various methods and accessories for mounting the switch in different locations.
Provides instructions for establishing a proper earth ground connection for the switch.
Guide to configuring the switch via its web-based graphical user interface.
Instructions for configuring the switch using the Command Line Interface.
To Next Page