Cisco cBR - User Manual

Installing the Supervisor in the Cisco cBR
Chassis
This section provides information on installing the Supervisor.
Check if your hardware might have a supervisor card. For supervisor cards that are shipped as a spare module,
the supervisor card bootflash would be empty. Ensure that you manually copy the image on the bootflash to
avoid issues while booting.
•
Installing the Supervisor 250G, page 1
•
Installing the Supervisor 160G, page 38
Installing the Supervisor 250G
Installing the Supervisor PIC in the Cisco cBR Chassis
Perform this procedure to install the following PICs:
•
Supervisor PIC
•
Blank PIC for the Supervisor
Do not support mix use of 250G and 160G SUP and SUP-PIC.Note
Before You Begin
If you are adding a new Supervisor PIC or upgrading the existing Supervisor PICs, ensure that the power
modules installed in the chassis are adequate to support the Supervisor PICs.
Warning
•
Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
connected to the chassis.
Cisco Converged Broadband Routers Hardware Installation Guide
1

Cisco cBR Specifications

General

Category	Network Router
Redundancy	Yes
Remote PHY Support	Yes
Remote MACPHY Support	Yes
Operating System	Cisco IOS XE
Interface	RF
Supported Interfaces	Ethernet, RF
Management	SNMP, CLI, Web UI
Product Name	Cisco cBR-8 Converged Broadband Router
Form Factor	Rack-mountable

Summary

Installing the Supervisor 250 G

Installing the QSFP+ or QSFP28 Transceiver Modules in the Supervisor PIC

Procedure for installing transceiver modules into the Supervisor PIC.

Installing the Supervisor 160 G

Installing the Supervisor PIC in the Cisco cBR Chassis

Installing the SFP+ Modules in the Supervisor PIC

Procedure for installing SFP+ modules into the Supervisor PIC.

Installing the Supervisor Card in the Cisco cBR Chassis

Procedure for installing the Supervisor Card into the chassis.

Using the Console Port on the Supervisor PIC

Swap Supervisor 160 G to Supervisor 250 G 10 GE Mode

Upgrade Supervisor 160 G to Supervisor 250 G 100 GE Mode

Backup the Configuration and IOS Code

Steps to back up configuration and IOS code for the upgrade.

Swap the Supervisor