Cisco cBR - Page 7

•
Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16"
flat-blade torque screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel.
Removing the FPEM from the Cisco cBR Chassis
Before You Begin
•
For an AC-powered Cisco cBR chassis, remove the AC power connections.
For an DC-powered Cisco cBR chassis, remove the DC power connections.
•
Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
connected to the chassis.
•
Remove the Power Modules.
•
If you are replacing the entire power system, remove the Power Cassette Module.
•
Be aware of the weight and size of the equipment. Handle it with care.
Required Tools and Equipment
•
ESD-preventive wrist strap
•
T10 Torx screwdriver
Cisco Converged Broadband Routers Hardware Installation Guide
7
Maintaining the Power System in the Cisco cBR Chassis
Removing the FPEM from the Cisco cBR Chassis