•
Antistatic bag
Step 1
Loosen and remove the four #6-32 Torx-head screws on the mounting flanges of the FPEM using a T10 Torx screwdriver.
Figure 5: Removing the FPEM from the Chassis
Step 2
Slide the FPEM out of the chassis using the handles on either side applying even pressure to both handles.
Step 3
Place the removed FPEM in an antistatic bag.
What to Do Next
Replace the FPEM (if required).
Cisco Converged Broadband Routers Hardware Installation Guide
8
Maintaining the Power System in the Cisco cBR Chassis
Removing the FPEM from the Cisco cBR Chassis
To Next Page
Loading...
