Cisco cBR User Manual

Redundant System Information :
------------------------------
Available system uptime = 4 days, 18 hours, 39 minutes
Switchovers system experienced = 2
Standby failures = 0
Last switchover reason = user forced
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 4
Current Software state = ACTIVE
Uptime in current state = 1 day, 23 hours, 59 minutes
Image Version = Cisco IOS Software [Fuji], cBR Software
(X86_64_LINUX_IOSD-UNIVERSALK9-M), Experimental Version
16.7.20171024:133607 [v167_throttle-/nobackup/mcgourtm/v167_throttle_ece2 103]
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Compiled Tue 24-Oct-17 12:43 by mcgourtm
BOOT = bootflash:cbrsup-universalk9.BLD_V167_THROTTLE_LATEST_20171019_050605.SSA.bin,12;
CONFIG_FILE =
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 5
Current Software state = STANDBY HOT
Uptime in current state = 1 day, 23 hours, 49 minutes
Image Version = Cisco IOS Software [Fuji], cBR Software
(X86_64_LINUX_IOSD-UNIVERSALK9-M), Experimental Version
16.7.20171024:133607 [v167_throttle-/nobackup/mcgourtm/v167_throttle_ece2 103]
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Compiled Tue 24-Oct-17 12:43 by mcgourtm
BOOT = bootflash:cbrsup-universalk9.2017-10-24_12.51_mcgourtm.SSA.bin,12
CONFIG_FILE =
Configuration register = 0x2102
Step 24
Save & backup current configuration.
copy running-config startup-config
Step 25
Copy the configuration into bootflash for backup.
copy running-config bootflash:sup250.cfg
copy running-config stby-bootflash:sup250.cfg
Step 26
Check the WAN port connection by ping the peer device.
Step 27
Check the system health and service with the following commands:
show version
show platform
show platform diag
show environment
show cable modem summary total
show processes cpu sorted
show logging
Cisco Converged Broadband Routers Hardware Installation Guide
33
Installing the Supervisor in the Cisco cBR Chassis
Swap Supervisor 160G to Supervisor 250G 10GE Mode

Cisco cBR Specifications

General

Category	Network Router
Redundancy	Yes
Remote PHY Support	Yes
Remote MACPHY Support	Yes
Operating System	Cisco IOS XE
Interface	RF
Supported Interfaces	Ethernet, RF
Management	SNMP, CLI, Web UI
Product Name	Cisco cBR-8 Converged Broadband Router
Form Factor	Rack-mountable