Cisco cBR - Page 42

•
Install the Supervisor PIC (recommended).
Required Tools and Equipment
•
ESD-preventive wrist strap
•
Supervisor PIC
•
Supervisor PIC cable management bracket
•
3/16" flat-blade torque screwdriver
Step 1
Align the captive screws on the Supervisor PIC cable management bracket with the mounting holes on the Supervisor
PIC.
Ensure that the upper slot in the cable management bracket is the smaller slot for fiber-optic cables and the
lower slot is the larger slot for RJ-45 cables.
Important
Figure 30: Installing the Supervisor PIC Cable Management Bracket
Supervisor PIC cable management bracket2Captive screws1
Step 2
Tighten the captive screws using a 3/16" flat-blade torque screwdriver with a torque of 6-8 in-lb (0.68-0.90 Nm) to secure
the Supervisor PIC cable management bracket.
What to Do Next
• Install the chassis-mounted fiber/cable routing guide (if not already installed).
Cisco Converged Broadband Routers Hardware Installation Guide
42
Installing the Supervisor in the Cisco cBR Chassis
Installing the Supervisor PIC Cable Management Bracket