•
You must use the supported QSFP28 modules. The following QSFP28 modules are supported on the
Supervisor PIC:
◦
QSFP-100G-SR4-S
◦
QSFP-100G-LR4-S
◦
QSFP-40G-SR4 with breakout cable
◦
QSFP-4x10G-LR-S with breakout cable
Required Tools and Equipment
•
Wrist strap or other personal grounding device to prevent ESD occurrences.
•
Antistatic mat or antistatic foam to set the transceiver on.
Cisco Converged Broadband Routers Hardware Installation Guide
7
Installing the Supervisor in the Cisco cBR Chassis
Installing the QSFP+ or QSFP28 Transceiver Modules in the Supervisor PIC
To Next Page
Loading...
