Cisco CISCO7201 - Cleaning the Fiber-Optic Connections

5-14
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Chapter 5 Troubleshooting Initial Startup Problems
Cleaning the Fiber-Optic Connections
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 7201 (c7201) processor (revision B) with 917504K/65536K bytes of memory.
Processor board ID 74832279
MPC7448 CPU at 1666Mhz, Implementation 0, Rev 2.2
1 slot midplane, Version 2.0
Last reset from power-on
1 FastEthernet interface
4 Gigabit Ethernet interfaces
2045K bytes of NVRAM.
250880K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x0
Cleaning the Fiber-Optic Connections
For information about cleaning fiber-optic cable connectors and receptacles, see the Inspection and
Cleaning Procedures for Fiber-Optic Connections document. It provides detailed illustrations and photos of
procedures and equipment required to properly clean fiber-optic connections. Also see the Compressed Air
Cleaning Issues for Fiber-Optic Connections document.