Cisco CISCO7201 - CHAPTER 4 Removing and Installing an SFP Module; Removing an SFP Module; Installing an SFP Module

4-2
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Chapter 4 Replacing Cisco 7201 Field-Replaceable Units
Removing and Installing an SFP Module
Removing and Installing an SFP Module
For SFP module specifications and product numbers, see Appendix A, “Specifications.”
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Warning Class 1 laser product. Statement 1008
Warning Class 1 LED product. Statement 1027
For general information about SFP modules, see the “SFP Module Information” section on page 1-5.
Removing an SFP Module
Use the following procedure to remove an SFP module:
Step 1 Make sure there is no traffic flowing through the native Gigabit Ethernet port.
Step 2 Remove the optical fiber cable, taking care not to touch the connector.
Step 3 Pull gently to detach the SFP module from the chassis.
Step 4 Insert a plug into the SFP module.
Installing an SFP Module
Use the following procedure to install an SFP module:
Figure 4-1 Inserting an SFP Module into the Cisco 7201 Gigabit Ethernet Port 0/1
1 Gigabit Ethernet port 0/1—SFP port 2 SFP module
170860
GE 0/0
GE 0/1
GE 0/2
GE 0/3
AUX
CONSOLE
MNGMNT USE ONLY
FE
LINK
0
FE 0/0
RJ45
SFP
SFP
SFP
SFP
LINK/ACTV
LINK/ACTV
RX
TX
LINK/ACTV
LINK/ACTV
RX
TX
EN
RJ45
EN
2
1
T
X
R
X
Cisco 7201