Cisco CISCO7201 - Page 165

Index
IN-7
Cisco 7201 Installation and Configuration Guide
OL-11364-04
setup facility
configuration 3-10
SFP module
about 1-5
configurations A-4
installation 4-2
online insertion and removal 1-5
specifications A-4
SFP plug 4-3
SFP port cabling specifications A-5
SFP ports supported with copper SFP module 2-19
SFP power budget A-5
shipping container contents 1-11
show commands
show controller 3-16
show diag 3-29
show environment 3-6, 5-6
show environment all 3-6, 3-7
show environment last 3-6
show environment table 3-6, 5-6
show hardware 3-29
show interface GigabitEthernet O/X 3-16
show interfaces 3-2
show rom-monitor 3-23
show running-config 3-21
show startup-config 3-21, 3-26, 3-27
show version 3-29
shutdown
environmental 3-4
fan failure 3-8
power supply 3-5
preventing administrative 3-28
processor 3-5
thresholds 3-4
Simple Network Management Protocol
See SNMP 3-13
site ambient temperature 2-4
site preparation 2-2
site requirements guidelines 2-4
slot/port numbers for interfaces 3-2
software requirements A-3
specifications
auxiliary port A-10
CompactFlash Disk configurations A-3
console port A-10
dimensions A-1
Gigabit Ethernet RJ-45 port pinouts A-6
heat dissipation A-1
power supplies A-1, A-2
processor and memory A-3
SFP module A-4
SFP port cabling A-5
weight A-1
speed command 3-15
startup
system 3-8
troubleshooting 5-3
status
environmental 3-6
interfaces 3-2
LED 5-2
STATUS LED 1-4
straight-through cable, Gigabit Ethernet/Fast
Ethernet/Ethernet pinout
A-8
subsystems for troubleshooting
cooling 5-3, 5-6
I/O 5-7
power 5-3, 5-4
processor 5-3
support, obtaining i-xviii
synchronous serial interfaces, configuring 3-19
system banner 3-9
system board components 1-9
system management functions 1-10