2-16
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Chapter 2 Installing the Cisco 7201 Router
Connecting I/O Cables
Figure 2-11 Identifying a Roll-Over Cable
The Cisco 7201 router ships with a roll-over cable. Connection to a terminal or a modem will require an
RJ-45-to-DB-25 adapter, and possibly a DB-25-to-DB9 adapter. Refer to
Table 2-3 for the cable and
adapter configurations that can be used to connect terminals and modems to the Cisco 7201 router.
Both ports are configured as asynchronous serial ports. Figure 2-12 shows the RJ-45 console and
auxiliary port connections.
1 Pin 1 3 Pin 8
2 Pin 1 and pin 8 should be the same color
84532
1 3
2
Ta ble 2-3 Asynchronous Device Cabling Options
Access Server Port RJ-45 Cable Type DB-25 Adapter End Device
Console or auxiliary Roll-over FDTE
1
1. The FDTE RJ-45-to-DB-25 adapter is labeled “Terminal”.
Terminal
Console or auxiliary Straight-through FDCE Terminal
Auxiliary or console Roll-over MMOD
2
2. The MMOD RJ-45-to-DB-25 adapter is labeled “Modem”.
Modem
To Next Page
Loading...
