Cisco CISCO7201 - Page 5

Contents
v
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Configuring a Cisco 7201 Router 3-9
Performing a Basic Configuration Using AutoInstall 3-10
Performing a Basic Configuration Using the Setup Facility 3-10
Configuring Global Parameters 3-11
Configuring the Native Gigabit Ethernet Interfaces 3-15
Configuring Port Adapter Interfaces 3-17
Performing a Basic Configuration Using Global Configuration Mode 3-20
Checking the Running Configuration Settings 3-21
Saving the Running Configuration to NVRAM 3-21
Performing Other Configuration Tasks 3-22
Upgrading ROMmon on the Cisco 7201 3-22
Using the show rom-monitor Command and showmon Command 3-23
Using the upgrade rom-monitor Command 3-23
Changing Preferences to Change the ROMmon Image 3-24
Troubleshooting the Upgrade 3-24
ROMmon Upgrade Error Messages 3-24
Upgrading FPGA 3-25
Replacing or Recovering a Lost Password 3-26
Overview of the Password Recovery Procedure 3-26
Details of the Password Recovery Procedure 3-27
Viewing Your System Configuration 3-29
Performing Complex Configurations 3-30
CHAPTER 4 Removing and Installing an SFP Module 4-2
Removing an SFP Module 4-2
Installing an SFP Module 4-2
Removing and Installing the CompactFlash Disk 4-3
Removing and Installing a USB Flash Memory Module or
USB eToken Pro Key 4-4
Removing and Installing a Port Adapter or Service Adapter 4-5
Removing and Installing an AC Power Supply 4-7
Removing the AC Power Supply 4-7
Installing the AC Power Supply 4-9
Removing and Installing a DC Power Supply 4-10
Removing the DC Power Supply 4-10
Installing the DC Power Supply 4-11
Installing the DC Grounding Leads 4-12
Wiring the DC-Input Power Source 4-13