Cisco CRS Series

SUMMARY STEPS
1.
Align the DC terminal block cover with the cover latch tab.
2.
Slide the terminal block cover upwards to align the screw with the mounting standoff.
3.
Use the screwdriver to secure the screw into the mounting standoff, see Figure 23: Securing the Terminal
Block Cover, on page 34. Tighten to a torque of 5 to 7 in.-lb.
DETAILED STEPS
Step 1
Align the DC terminal block cover with the cover latch tab.
Step 2
Slide the terminal block cover upwards to align the screw with the mounting standoff.
Step 3
Use the screwdriver to secure the screw into the mounting standoff, see Figure 23: Securing the Terminal Block Cover,
on page 34. Tighten to a torque of 5 to 7 in.-lb.
Figure 23: Securing the Terminal Block Cover
What To Do Next
After you install the DC input cables and DC terminal block cover, re-install the rear exhaust air deflector.
Continue to the Installing the Exhaust Air Deflector, on page 37 for instructions.
Installing AC Power Cords
This section describes how to install input AC cords on the rear of the power shelf.
When installing AC power cords on the power shelf, be sure to connect the chassis ground cable first. For
more information, see the Bonding and Grounding Guidelines, on page 2 and the Installing the Chassis
Ground Cable, on page 19.
Note
Cisco CRS Routers 16-Slot Line Card Chassis Enhanced Router Installation Guide
34
Installing Power Components
Installing AC or DC Power Shelf Wiring