Step 5
Remove the logo bezel (see the figure below) by unsnapping it from the ball stud snaps on either side of the bezel support,
and then set it carefully aside.
Step 6
Remove the upper grille (see the figure below) by unsnapping the bottom portion from the ball stud snaps on the logo
bezel support assembly.
Step 7
Rotate the grille toward you on its hook hanger brackets, then lift it clear of the support, and set it carefully aside.
Figure 13: Removing the Logo Bezel and Front (SFC) Side Upper Grille
—
Fixed Configuration Power Shown
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
19
Installing and Removing Exterior Cosmetic Components
Steps
To Next Page
Loading...
