Step 10
Insert the four short Phillips screws (two on each side) that attach the bracket to the inside of the vertical cable troughs,
and tighten them to the troughs with the screwdriver.
Step 11
Attach the rear lower horizontal cable guides (see the figure below) by inserting four longer Phillips screws through the
holes in the face of the brackets and into the chassis and tightening them to the chassis with the screwdriver.
Figure 25: Attaching the Rear Lower Horizontal Cable Guide
6 mm long screw attaching cable guide to chassis (quantity=
4)
1
4-mm long screw attaching cable guide to vertical trough
(quantity=4)
2
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
35
Installing and Removing Exterior Cosmetic Components
Steps
To Next Page
Loading...
