Step 12
Insert the four short Phillips screws (two on each side) that attach the bracket to the vertical cable trough support flanges
and tighten them to the troughs with the screwdriver.
Step 13
Attach the rear upper grille by carefully hooking the tabs on the top of the grille over the hook supports on the top of the
vertical cable troughs (see the figure below).
Figure 26: Attaching the Rear (OIM) Side Upper Grille
—
Fixed Configuration Power Shown
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
36
Installing and Removing Exterior Cosmetic Components
Steps
To Next Page
Loading...
