Step 14
Press the grille firmly against the grille support until it snaps onto the ball stud snaps on the rear (OIM) side of the chassis.
Step 15
Attach the rear lower bezel by carefully inserting the tabs on the grille into the hook hanger brackets on the lower bezel
frame. Press the grille firmly against the grille frame until it snaps onto the ball stud snaps on the rear (OIM) side of the
chassis (see see the figure below).
Figure 27: Attaching the Rear (OIM) Side Lower Bezel
Ball stud2Hook hanger brackets1
Step 16
Orient the doors so that the keyhole slots are pointing up.
The doors scratch easily, so they should be handled with
care.
Caution
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
37
Installing and Removing Exterior Cosmetic Components
Steps
To Next Page
Loading...
