Cisco CRS - Page 45

Step 4
Use the screwdriver to remove the four screws (two on each side) that attach the bracket to the vertical cable trough
support flange (see the figure below), and set them aside.
Step 5
Using the screwdriver, remove the five longer Phillips head screws that attach the face of the bracket to the chassis.
Remove the cable guide and carefully set it aside. (see the figure below)
Figure 33: Removing the Rear Upper Horizontal Cable Guide
6 mm long screw attaching cable guide to chassis (quantity=
5)
1
4-mm long screw attaching cable guide to vertical trough
(quantity=4)
2
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
45
Installing and Removing Exterior Cosmetic Components
Steps