Cisco CRS - Page 46

Step 6
Use the screwdriver to remove the four flat head Phillips screws, two on each side, that attach the cable guide to the
chassis, and set them aside. See the figure below.
Step 7
Using the screwdriver, remove the five flat head Phillips screws that attach the cable guide to the chassis. Remove the
cable guide and carefully set it aside. See the figure below.
Figure 34: Removing the Rear Mid-Chassis Horizontal Cable Guide and Strike Tube
4 mm long screw attaching cable guide to vertical trough
(quantity=4)
1
6 mm long screw attaching cable guide to chassis
(quantity=5)
2
Strike tube on the upper surface3
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
46
Installing and Removing Exterior Cosmetic Components
Steps