Back Panel Description
The following illustration identifies the back panel components on the DPC2320 and
EPC2320 residential gateways. Descriptions for each component follow the
illustration.
1 POWER—Connects the residential gateway to the AC power adapter that is
provided with your residential gateway
Important: Use only the power supply provided with your residential gateway.
CAUTION:
Avoid damage to your equipment. Only use the power supply that is provided
with your residential gateway.
2 ON/OFF SWITCH (Provided only on products that carry the CE mark)—
Allows you to turn off of the residential gateway without removing the power
cord. Turning the residential gateway off using this switch ensures that the unit
is consuming no energy.
3 ETHERNET—One RJ-45 Ethernet port connects to the Ethernet port on your PC
or your home network
4 MAC ADDRESS LABEL—Displays the MAC address of the residential gateway
5 CABLE—F-connector connects to an active cable signal from your service
provider
To Next Page
Loading...
