Configuring Remote Bridges
Use the Setup Wireless - Bridging page to configure your configure remote bridges.
Note: If you are not familiar with the advanced settings detailed in this section,
contact your service provider before you attempt to change any of the wireless home
gateway default wireless advanced settings.
Click Bridging in the Wireless section of the Setup page to access the Setup Wireless
- Bridging page.
Setup Wireless Access Control Page Example
The following illustration is an example of the Setup Wireless - Bridging page.
Setup Wireless - Bridging Page Description
The Setup Wireless - Bridging page allows you to Enable or Disable wireless
bridging and to add remote bridges. Click Apply to apply and save your new
settings.
To Next Page
Loading...
