Chapter 3 Configuring the DOCSIS Residential Gateway
Setup Basic Settings - Enable/Disable Time Synchronization by Network Time Protocol
The following illustration is the initial view of the Basic Settings Enable/Disable
time synchronization by Network Time protocol page.
Setup Basic Settings - Enable/Disable Time Synchronization by Network Time Protocol Page
Description
The following table provides a description of the fields within the Basic Settings
Enable/Disable time synchronization by Network Time protocol page.
Displays the current system time and date.
Allows you to enable or disable network time protocol
Note: The residential gateway will automatically use the time
server in your broadband network. Should there be no current
time displayed or if the network time is incorrect, enable Network
Time Protocol to use a public Internet time server to set the clock
in the gateway.
Displays the time and date of the last successful time update.
Displays the current time zone. The drop-down list allows you to
select your local time zone.
Allows you to adjust the time during periods when Daylight
Saving Time is in effect. Check the Enable box to enable or disable
this setting.
Note: If the offset for Daylight Savings Time is other than 60
minutes, enter the offset in the minutes field.
To Next Page
Loading...
